sync3

273/305

008000500050080005005100510051000500050051OUTDOORDUAL SPOTLGHTMN50GLARE-LESSP44sync liteDOWNLGHTP65 LNEARLGHTUNDERWATER198mm,,,,,,,,IIIII,II IOUTDOORGLARE-LESS UNDERWATER27312,5001,8001,80012,5001,8001,800#The wave tube should reach the bottom of the rubber plug##The distance between these holes and the ground should less than 1m.#12,5002,4002,40012,500reach IP68#25,0005,0005,000Layout A / Pitch= 1.8mBeam angle= 38 x 88 degreeLayout A / Pitch= 1.8mBeam angle= Spread 32 x 73 degree1-1. Put the wave tube through the nut and the rubber plug.5-1. Fix the two type “L” bracket on the mounting sleeve.5-2. Dig a hole for the installation for each of the mounting sleeve.2-1. Fasten the nut with the screw by using a tool.6-1. Put the mounting sleeve into the holes.6-2. Fasten it with the wall of the pool by a screwdriver.Layout B / Pitch= 2.4mBeam angle= 38 x 88 degreeLayout B / Pitch= 1.5mBeam angle= Narrow 14 degreeLayout B for wide pool / Pitch= 1.5mBeam angle= Narrow 14 degree3-1. Put the cable through the wave tube and the hole of the mounting sleeve from outside.3-2. Then insert the cable into the nut/rubber plug and the screw of the PG13.5.3-3. Fix the nut with screw of the PG13.5 tightly.7-1. Connect the lighting fixture with the power cable by the connector.#fasten the connector tightly to make sure it can 7-2. Turn on the power to make sure it is working.7-3. Fix the light with the mounting sleeve by a screwdriver.Mounting Height = 0.8mBeam angle= 38 x 88 degreeMounting Height = 0.8m4-1. Screw the PG13.5 with the connector on the wave tube tightly with two wrenches.4-2. Fix the backcover to the mounting sleeve 8-1. Pour the water into the pool after the by four screw.installation.How to installUnderwater floor washer ▶ P. 268Underwater linear light ▶ P. 270Installation Manual